Results 1 to 18 of 211

Thread: Completed: DIY DRC removal/swap with Koni Yellow Sports....

Hybrid View

  1. #1
    Registered User
    Join Date
    Jan 2012
    Location
    Seattle, WA
    Posts
    287
    Quote Originally Posted by 4.2Crew View Post
    Yes, I took measurements from the axle center to the top lip of the wheel wells on all 4 corners 10 minutes prior to tearing into it...
    So when done, the setting was how close to stock ride height? I would imagine if a spring compression measurement was taken before removing the springs from the DRC, and then matching that to whichever groove on the Koni yielded the same measurement, and then provided that the perch to bottom mount centerline measurement is the same (Koni probably copies it), then it should be close to stock ride height. Was that the case for the front?

    Please give a 1000 mile report. It will also be interesting to see if you feel the need to upgrade the swaybars, since DRC is supposed to be an "active swaybar" there when you need it, and not affecting ride quality when you don't.

    Lastly, again, that lift is killer!

    Thanks for the report!
    Daytona/Ebony/Carbon/SEE/RNS-E/19X9 Speedline "Peelers"

  2. #2
    Registered User 4.2Crew's Avatar
    Join Date
    May 2011
    Location
    MN
    Posts
    333
    Quote Originally Posted by NSU RS6 View Post
    So when done, the setting was how close to stock ride height? I would imagine if a spring compression measurement was taken before removing the springs from the DRC, and then matching that to whichever groove on the Koni yielded the same measurement, and then provided that the perch to bottom mount centerline measurement is the same (Koni probably copies it), then it should be close to stock ride height. Was that the case for the front?

    Please give a 1000 mile report. It will also be interesting to see if you feel the need to upgrade the swaybars, since DRC is supposed to be an "active swaybar" there when you need it, and not affecting ride quality when you don't.

    Lastly, again, that lift is killer!

    Thanks for the report!
    To answer your questions:

    Yes, the height is within 1/16" on each corner as before the swap...

    Compressed spring measurements: Short answer, yes... I wasn't too concerned about the compressed measurement, but it was within 1/4" on fronts and rears...

    I drove the car about 60 miles today to get the alignment trimmed back in after the swap.... Wow, what difference! Quiet, compliant, smooth, sporty and luxurious ride! I can tell the DRC did assist the sway bars... Not night and day, but there is a difference.
    2003 RS6 l SE Exhaust l Koni Yellow Sports w/stock springs l Lowered 1"F 1.25"R l EPL Tuned l 19 x 9.5 VMR V713 & 265 PSS's l 50% window tint l Protective film on entire hood, bumper and front quarter panels l

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •