Pictures of the MTM catalysts

[keo]

I have add some new pictures on my gallery (www.fountaincan.com.tw/keo)

You can see the different after swap of 4 springs. As you can see the front end is lower than previous. But the back cannot see any different. But the car is sure more stable on cornering. Also I have took 2 pictures with MTM downpipe attach to the catalysts underneath the bottom of the car. you can see why I scratch the converter everytime i am going down the basement parking lot.

Eric..please help me attach the picture to the forum..thankyou..

[Erik]

Very nice car!

[RS4Ever]

very very cool pics

love the look

[Erik]

keo, what is the name/make of the sun film?

[keo]

Eric, what do you mean by sun film??????

I am picking up my car today. Hopefully, they have improve the converter position so that it will not scratch it during high n low entrance..

[nene]

Very nice beast.

I think the tint (sun film) is stock. If you see it at a certain angle, it looks like that on our beasts.

[keo]

The tint... ...it's 3M(brand)...that all i know....

[Chuangs4]

Keo, the front lower too much. You should check up that spring rate.

Beside this, that is indeed a beautiful car!!

[keo]

chuangs4, you are right I have already adjust the spring height, thanks for the advice....

[audirs6sport]

well there's a good reason why those springs out there lower the front more than the rear. for cars with engine in the front, that's where it's most heafty. therefore, lowering the front part of the chassis more will lower the center of gravity effectively.

[minimad]

please chk your PM, thx!