I left the sensor in the bell housing the whole time. I just checked and it is connected so I'm not convinced about that. Is there a block I can monitor to see if it is OK or not?
Going through the coding in VCDS:
17-Instruments -> Adaptation -> Ch 60 is set to 1025 (+0001 Engine & +1024 Instrument Cluster)
01-Engine -> Coding -> set to 0006752 but I think it should be 006712. I get an Out of Range error when I try that.
03-ABS Brakes -> Login: 07197 (6mt code doesn't work)-> Coding is set to 06697 but should be 06695. I cannot get this to change, probably because I can't clear the Missing Message from TCU error because. Guessing I can't clear this until I can get the Engine coding changed?
I have the TCU removed fyiy.