Mine has a pin hole leak. If I cAn find a good used one would prefer over welding.
Mine has a pin hole leak. If I cAn find a good used one would prefer over welding.
Diagram showing the part in question, a description, or even a photo, would all go a long way to assisting those that don't have software parts programs.
'02 S6 Avant Silver - Pokey | Carbon Black/Ebony RS6 w/ stuff - darn quick | '03 Daytona Grey/Ebony RS6 w/ more stuff - quicker yet | '91 NSX CDN issue with 6spd & BBSC - quicker yet and then some | '87 Buick GNX OEM clone w/ lots of stuff - quickest hands down
For what it's worth, a quick googling says that it's the black steel pipe on the upper section of the photo:
I might have one of these and will get back to you.
2012 Q7 TDI S-Line - 2010 GTI - 2007 A3 3.2 S-Line - 2003 RS6
2001 Honda S2000 - 1977 Honda CBR 750-F2 - 1965 GMC 1500 WideSide
Correct. That's the one. Before I tore the car apart I knew there was a leak on that side. I assumed it was the radiator. Had that tested and cleaned. Good to go there. Reassembling now. Very close and saw peeling paint and rust in a couple of spots. 90% sure without testing this is the leak. Could pressure test but just assuming that's it and would like to replace. Not going to spend 210 on a small steel pipe. If no other options, I'll just repair but would prefer new or good used. I'll get a pic if really needed. No problem. I'll do it tomorrow
I just confirmed that I have one.
You should have my cell number. Text me and I'll send you a pic and work out any details.
2012 Q7 TDI S-Line - 2010 GTI - 2007 A3 3.2 S-Line - 2003 RS6
2001 Honda S2000 - 1977 Honda CBR 750-F2 - 1965 GMC 1500 WideSide