Page 2 of 2 FirstFirst 12
Results 19 to 20 of 20

Thread: VMR V702 19x9.5 et33 install

  1. #19
    Registered User lswing's Avatar
    Join Date
    May 2011
    Location
    Eugene, OR, again...
    Posts
    4,760
    Well I'm a bit late to the party, but went to install this same (almost see below) setup today and serious rubbing. All I can figure is the Sport 4S tire is much bulkier than the PSS. Going with 10mm spacers for now, and might grind the control arm nub down some, but don't really like that idea. Thoughts?

    VMR V702 19x9.5 et33 install. Only thing i did different was use a 265/35/19 as opposed to the 255/35/19 as it was recommended on another thread as a better fit by the OP, but it turns out that .4" extra width is too much with Sport 4S at least.

    Looking back the 255 had a 10" width that may have fit a better over the 9.5" wide wheel...although as mentioned the 255 was going to be a stretch with the PSS so I heard.

    Lovely setup though, some serious traction.

    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	tire1.jpg 
Views:	496 
Size:	82.1 KB 
ID:	19340   Click image for larger version. 

Name:	tire2.jpg 
Views:	310 
Size:	67.6 KB 
ID:	19341   Click image for larger version. 

Name:	tire3.jpg 
Views:	303 
Size:	57.8 KB 
ID:	19342  
    Last edited by lswing; October 10th, 2020 at 21:06.
    Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com

  2. #20
    Registered User lswing's Avatar
    Join Date
    May 2011
    Location
    Eugene, OR, again...
    Posts
    4,760
    I ended up swapping back to the 255/35/19. Michelin has a no questions 60 day exchange policy which was very quick and easy.

    The 265/35/19 is a very bulky tire, even at .3 to .4 inches taller and wider it's a huge difference. With the 10mm spacers it did fit but just looked a bit goofy to me, and the higher sidewalls were a bit soft under cornering. I probably could have got rid of the spacers after grinding down the control arm nub, but still felt it was too much rubber for the car.
    Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •