RS6 c5 1/8 mile drag

[LINIS]

Sorry for a new thread.
I've tested my beast on 1/8 mile drag and the results were horrible:
RT SPEED km/h. ET ET+RT
Run 1 0.883 129.5 9.593 10.476
Run 2 1.015 124.1 9.701 10.716
Run 3 0.791 123.3 9.843 10.634
Run 4 0.441 125.4 9.870 10.311

Ok, we were two people in the car, and it was a very hot day 86 degrees by Farenheit, but my beast had tuned up to 513hp and more than 497 lb-ft by dahlback.. Where might be the problem, I have noticed that the car has lost all its power.. After 60 mph it gets alive again..
What are your suggestions?

[DHall1]

A data log

Or pay someone to data log your car

Sorry for a new thread.
I've tested my beast on 1/8 mile drag and the results were horrible:
RT SPEED km/h. ET ET+RT
Run 1 0.883 129.5 9.593 10.476
Run 2 1.015 124.1 9.701 10.716
Run 3 0.791 123.3 9.843 10.634
Run 4 0.441 125.4 9.870 10.311

Ok, we were two people in the car, and it was a very hot day 86 degrees by Farenheit, but my beast had tuned up to 513hp and more than 497 lb-ft by dahlback.. Where might be the problem, I have noticed that the car has lost all its power.. After 60 mph it gets alive again..
What are your suggestions?

[LINIS]

I guess I need to give my car to someone to connect it with pc and using some software it is possible to make the data log?

[lswing]

Yep, ross-tech and Windows laptop...

Weight makes a big difference, same with heat...plus, that tune sounds low on torque, I'm roughly 500/550 at engine.

[ttboost]

As everyone said, datalog and see if you have any issues. At that power level, I wouldn't expect too much more.

...and who goes dragracing on a hot and muggy day? You are a full second slower than normal and 5-10mph slower than normal. Try again and leave your friend at the starting line...

[LINIS]

Thanks for support guys! I'll check the beast for issues and post here the results later..