Results 1 to 10 of 10

Thread: Replacing seat power gear cluster

  1. #1
    Registered User lswing's Avatar
    Join Date
    May 2011
    Location
    Eugene, OR, again...
    Posts
    4,760

    Mech Replacing seat power gear cluster

    Anybody ever do this? Seat moving around is driving me crazy, looked underneath and the adjustment gears are plastic, some of mine are broken. We have able to wedge tinfoil in the gears to make it better. I want the damn thng replaced. Looked on etka a while back, not sure if a part number was listed, might try a used one from low mileage car, how tough to replace?

    Thanks! What a pain...
    Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com

  2. #2
    Registered User ben916's Avatar
    Join Date
    Nov 2006
    Location
    Newcastle, WA
    Posts
    4,997
    Mine rocks a little forward/aft, just a little, but enough to notice.
    This also was apparent on the vehicle known as pre "special sauce"

    I would love to know how to fix it as I know my 165lb a$$ isn't big enough to cause this problem.

    I would rather solve this with a set of Euro C5 RS6 Recaros and be done with it
    SOLD - 03 RS6 Avus (905355)
    Current - 03 Toyota Tacoma 4x4 double cab - the YETI, lifted, winched, snorkeled, lockered, skidded, geared

  3. #3
    Registered User lswing's Avatar
    Join Date
    May 2011
    Location
    Eugene, OR, again...
    Posts
    4,760
    Well i'm 220 now and the damn thing rocks too much. With my brakes and suspension dialed in it's even worse. Tinfoil trick helps a good amount. Get somebody under there, rollup to about 10-20 layers thick, move seat out of place, then wedge in and move back to place.

    Looks like a bitch to replace that cluster, must be done...
    Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com

  4. #4
    Registered User ben916's Avatar
    Join Date
    Nov 2006
    Location
    Newcastle, WA
    Posts
    4,997
    Have you reached out to Saul Morse to see if those seats are gone?
    What about Kyle's "Deer"ly departed RS6? (sorry Kyle, I couldn't resist)
    SOLD - 03 RS6 Avus (905355)
    Current - 03 Toyota Tacoma 4x4 double cab - the YETI, lifted, winched, snorkeled, lockered, skidded, geared

  5. #5
    Registered User
    Join Date
    Dec 2010
    Location
    Charleston, SC
    Posts
    600
    I've got the two front seats out on the garage floor from my allroad if you need any parts or guidance (my allroad seats did not have seat memory module, FWIW). Did a full C5 A6 sport seat swap so I should be able to help out with DIY (remotely!). Same physical seat hardware as RS6 just not nappa leather and a little different bolster design. Removal of seats are not that bad, just cumbersome. The electrical module up under there is impossible to replace with the seat in. Here is a start... the plastic pieces which break down over time and cause rocking. The is also a link on this first post for seat removal. I just tried to pull up this link and it wouldnt pull althrough I know its good. I think audiworld might be having some issues this evening... http://forums.audiworld.com/showthread.php?t=1730763
    03 RS6 :: 01 allroad

  6. #6
    Registered User
    Join Date
    Dec 2010
    Location
    Charleston, SC
    Posts
    600
    Here is the install link I thought was inside the other link... http://forums.audiworld.com/showthread.php?p=15063018
    03 RS6 :: 01 allroad

  7. #7
    Registered User lswing's Avatar
    Join Date
    May 2011
    Location
    Eugene, OR, again...
    Posts
    4,760
    Good info, thanks.

    So who's selling me a low mileage rs6 drivers seat?
    Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com

  8. #8
    Registered User ben916's Avatar
    Join Date
    Nov 2006
    Location
    Newcastle, WA
    Posts
    4,997
    And what color are you looking for?
    Shokan?

    or -> http://www.ebay.de/itm/Audi-RS6-4B-L...item2320c13f3b

    NVM, that is for an AVANT
    Last edited by ben916; February 12th, 2013 at 05:12.
    SOLD - 03 RS6 Avus (905355)
    Current - 03 Toyota Tacoma 4x4 double cab - the YETI, lifted, winched, snorkeled, lockered, skidded, geared

  9. #9
    Registered User lswing's Avatar
    Join Date
    May 2011
    Location
    Eugene, OR, again...
    Posts
    4,760
    Black, stock...very good condition as mine is just worn a bit.
    Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com

  10. #10
    Registered User
    Join Date
    Sep 2010
    Location
    Los Angeles, CA
    Posts
    613
    I don't suppose the new S4 seats fit our car. My friends seats are so comfy.
    2003 Daytona/Silver RS6

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •