Search:

Type: Posts; User: hahnmgh63

Page 1 of 20 1 2 3 4

Search: Search took 2.62 seconds.

  1. Yes, just use the Mann W719/30. They were a...

    Yes, just use the Mann W719/30. They were a supplier to Audi, and yes, the RS6 filter also fit some of the 1.8t's. I had a 225bhp Audi tt that used the same filter as my RS6, also the same coilpack...
  2. Thread: EGT Sensors

    by hahnmgh63
    Replies
    2
    Views
    251

    These are the part #'s for the EGT's from the...

    These are the part #'s for the EGT's from the ETKA catalog:

    temperature sensor
    3 pin left 077919529E

    temperature sensor
    3 pin right 077998124

    repair set for temperature sensor
    3 pin...
  3. Thread: EGT Sensors

    by hahnmgh63
    Replies
    2
    Views
    251

    19757 They can be removed with the...

    19757
    They can be removed with the engine/transmission cradle lowered, tilted down more at the back that way you can leave the coolant lines at the front connected. In the pic above you can zoom in...
  4. Thread: HVAC Issue

    by hahnmgh63
    Replies
    7
    Views
    1,157

    Sorry but I completely forgot I had a couple of...

    Sorry but I completely forgot I had a couple of manuals that will probably help. PM me your email address and I'll send them to you. They are just a little over 3MB each.
  5. Replies
    4
    Views
    514

    19754 It can be done no doubt with the engine in...

    19754
    It can be done no doubt with the engine in but I think you'll have to put a hoist or crossbar across the top of the engine to hold it up as you will need to drop the whole subframe which means...
  6. Replies
    4
    Views
    514

    What is leaking? The Sandwich plate, the small...

    What is leaking? The Sandwich plate, the small Cooler, or the larger Aluminum Casting that the Cooler is bolted too? There are aftermarket alternatives if the Oil filter/Cooler Sandwich plate is bad...
  7. Thread: HVAC Issue

    by hahnmgh63
    Replies
    7
    Views
    1,157

    Don't know if it works as I'm over 2,000mi from...

    Don't know if it works as I'm over 2,000mi from my car but this is what I found:

    Accessing On-Board Diagnostic codes
    Press and hold the recirculation button. Then press the manual flow control up...
  8. Thread: HVAC Issue

    by hahnmgh63
    Replies
    7
    Views
    1,157

    Are you getting a code? Other than using Vagcom I...

    Are you getting a code? Other than using Vagcom I thought there was a procedure for putting the Climate Control head into some kind of diagnostic mode? Anyone?

    P.S.
    Might be a start, now we just...
  9. Replies
    1
    Views
    481

    Looks impressive but I'd like to see those...

    Looks impressive but I'd like to see those accelerations specs. I'm surprised they got the weight down. I do like the look of the Avants but I really don't have a need as I have a Turbo Cayenne and...
  10. Replies
    644
    Views
    1,050,201

    Sticky: A lot of pretty good looking cars showing up...

    A lot of pretty good looking cars showing up again. I think at this point I'll be keeping mine forever although I don't drive it much anymore. I've got around 73k but bought it with 13k miles.
  11. Replies
    1
    Views
    1,936

    Found in Honolulu Craigslist

    https://honolulu.craigslist.org/oah/cto/d/honolulu-2004-audi-rs6-mtm/7675127031.html
  12. Thread: Coolant Leak

    by hahnmgh63
    Replies
    10
    Views
    3,053

    https://www.gruvenparts.com/4-2l-audi-vw-billet-oi...

    https://www.gruvenparts.com/4-2l-audi-vw-billet-oil-cooler-tube/
    The plastic pipe just disintigrates after years of use, it's only about 2" long. There are of course the hoses that go to that...
  13. Thread: Coolant Leak

    by hahnmgh63
    Replies
    10
    Views
    3,053

    Did you ever replace the cheap OEM small Coolant...

    Did you ever replace the cheap OEM small Coolant pipe between the Coolant to Oil exchanger with an Aluminum Bufkin pipe? If that is leaking it is an engine pull or at least an engine drop of almost...
  14. Replies
    1
    Views
    838

    I don't think you'll have much of a choice but to...

    I don't think you'll have much of a choice but to drop the engine/transmission for the oil return line. You may be able to get away with just lowering the whole assembly down 6~8" so you don't have...
  15. Steve Ken is the man, if he doesn't answer this...

    Steve Ken is the man, if he doesn't answer this post he's on Audizine sometimes.
  16. Replies
    1
    Views
    622

    Final Drive, Automatic Transmission, Checking Oil...

    Final Drive, Automatic Transmission, Checking Oil Level and Filling
    FWD and AWD

    – Remove filler plug for fluid fill opening (arrow).
    – Check fluid level: fluid must be filled to...
  17. Replies
    4
    Views
    1,165

    Probably going to need to find a ZF rebult unit...

    Probably going to need to find a ZF rebult unit as it looks like Audi has discontinued the part. But it is a standard ZF design so I'm sure the parts availability for rebuilding from ZF and other...
  18. Replies
    4
    Views
    1,165

    https://www.urotuning.com/products/power-steering-...

    https://www.urotuning.com/products/power-steering-pump-audi-a8-a6-s8-s6-rs6?variant=42289818206401
    Don't know anything about the quality of Cardone rebuilt products but this is pretty cheap.
  19. Replies
    5
    Views
    1,058

    Right off hand I think I have the Apikol mounts...

    Right off hand I think I have the Apikol mounts myself. I know I have the Stearns engine mounts. I have the softer street version transmission mounts. Between the Stearns and the Apikol mounts there...
  20. Replies
    5
    Views
    1,058

    Not sure if there is enough room to raise the...

    Not sure if there is enough room to raise the transmission itself enough. Can partially raise the transmission and just lower the back of the cradle an inch or two. Just loosen the front cradle bolts...
  21. Replies
    5
    Views
    1,058

    Should be no problem, just check the downpipes...

    Should be no problem, just check the downpipes clearance. I have Miltek downpipes and can't remember if the OEM downpipes give any clearance issues getting the brackets off.
  22. Replies
    3
    Views
    570

    Well, I'd think with the Wagners it would be...

    Well, I'd think with the Wagners it would be running cooler. I'd imagine your Stg3 2.7t has aftermarket Intercoolers too?
  23. Replies
    3
    Views
    570

    That's a good question. I am 2k miles away from...

    That's a good question. I am 2k miles away from my car but I'll have to log the temps when I get to it. I'll have to log the temps on my '13 S5 3.0 Supercharged Stg2+ and see how they're doing. I do...
  24. Yes if it's an Auto, if it's a 6spd you can...

    Yes if it's an Auto, if it's a 6spd you can probaby pull just the transmission. Sorry, my post above was a little misleading when I just said a transmission pull. With the Auto you have to take them...
  25. Replies
    2
    Views
    423

    Should be fine. You just helped rust proof your...

    Should be fine. You just helped rust proof your car. With the oil cap back on you can spray some brake cleaner around the area, it does a good job of cleaning up the oil residue and evaporates fairly...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4