Search:

Type: Posts; User: bethridg

Page 1 of 15 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    80

    How many C5 RS6s are left?

    There's always talk about how many C5 RS6's were produced, imported to the US, interior/exterior combinations, etc.

    When I did my 6-speed swap I pivoted to tracking how many swaps existed. I...
  2. Replies
    8
    Views
    125

    I always highly recommend relocating the SJP. The...

    I always highly recommend relocating the SJP. The last time this subject was brought up I did a little write-up. Muggy did a good job of describing the replacement process. Relocating only serves the...
  3. Y'all are over thinking it. Grab some Permatex...

    Y'all are over thinking it. Grab some Permatex Ultra Black. Spread a thin film around the cam seals, cam end cap seals and half moon seals (including the flat). I add a little more sealant to the...
  4. I've used the Blau kit before. If you're going as...

    I've used the Blau kit before. If you're going as far as replacing the cam seals while you're in there add a little RTV to the outside of seals before tapping them in.
    ...
  5. To my knowledge, there is no OE part number for...

    To my knowledge, there is no OE part number for just the pads. However, you can find them all over ebay, Amazon, <strike>all the major Audi suppliers (Ecs, FCP, EuropaParts, AutohauzAZ) probably...
  6. Replies
    3
    Views
    510

    Half moon seal and/or cam tensioner gasket....

    Half moon seal and/or cam tensioner gasket. Should be easy to spot with the motor out but it's been a long time since I had a motor with all the emissions nonsense in the way.
  7. Replies
    17
    Views
    3,222

    Follow-up on the Ringer Racing Stage 4 Plus...

    Follow-up on the Ringer Racing Stage 4 Plus clutch ~13k miles later. The wear is phenomenal compared to the AMD Stage 3+ with similar mileage. Still plenty of meat on the clutch disc. It was...
  8. Replies
    2
    Views
    576

    Attached are the two related documents that I...

    Attached are the two related documents that I have.

    19130
    19131
  9. Shifter lock cable from the steering column /...

    Shifter lock cable from the steering column / ignition. Probably cut it when you pulled the 5tip. 8D1713575
  10. Replies
    6
    Views
    892

    That sucks. I ran into a problem years ago...

    That sucks. I ran into a problem years ago sourcing a direct replacement radiator. All of the aftermarket options claim to fit the RS6 but lack the 3rd coolant port for the after run pump unique to...
  11. Replies
    89
    Views
    11,137

    I ran into the exact same situation when Daz...

    I ran into the exact same situation when Daz remote tuned my car. It's how I found out mine had an MTM chipped ecu & tcu. Fortunately at the time he had one on his shelf he sent to me.


    I don't...
  12. Smoking Tire posted this a while ago but figured...

    Smoking Tire posted this a while ago but figured everyone would have seen it by now. Farah doesnt yell at you PLUS he actually drives the car...



    https://youtu.be/3mjQTNSSyYw
  13. Behind the lower center grille; originally...

    Behind the lower center grille; originally attached to the plastic duct that feeds the oil/trans cooler if you still have it. Drivers side as nubcake mentioned. Will look something like this.
    ...
  14. Replies
    89
    Views
    11,137

    I'm not saying your motor hasn't been apart...

    I'm not saying your motor hasn't been apart recently but I had the same sharpie L & R on the two BCYs I have in my possession. Change the tensioner pads! You truly don't know the history, especially...
  15. I do not have any experience with the Audi 100...

    I do not have any experience with the Audi 100 pump. From the outside, they appear to be the same as the RS6/S6/A6-4.2 units. However, comparing across multiple aftermarket manufacturers (rockauto)...
  16. Replies
    89
    Views
    11,137

    I just pulled these fasteners off my spare block....

    I just pulled these fasteners off my spare block. 7mm hex socket. If you have something different it's something I haven't come across one these motors and I'm really curious.

    19013
    19014
    ...
  17. Replies
    89
    Views
    11,137

    OG 6-speed swappers coming out of the wood work...

    OG 6-speed swappers coming out of the wood work to share the knowledge :)


    GreggPDX covered most everything.

    Manifold: I'm pretty sure the manifold nuts should be hex key centered. I don't...
  18. Replies
    16
    Views
    2,141

    hahnmgh63, Are you still running stock turbos...

    hahnmgh63,

    Are you still running stock turbos or did I miss you upgrading to SRM hybrids?
  19. I have a brand new brake booster in the box. Make...

    I have a brand new brake booster in the box. Make me an offer if you're interested.
  20. Replies
    3
    Views
    551

    For manifold flanges, I've had these on my watch...

    For manifold flanges, I've had these on my watch list for a few years now.
    ...
  21. Replies
    11
    Views
    2,080

    The radiator is most definitely specific to the...

    The radiator is most definitely specific to the RS6 and not shared with any other trim level. Your options are limited for replacement. They may still be available from Audi but I've seen plenty of...
  22. Replies
    16
    Views
    2,334

    Something else is wrong if you're really slipping...

    Something else is wrong if you're really slipping that clutch especially with your timing being fucked.
  23. Replies
    204
    Views
    172,565

    It did cross my mind...but I don't have anything...

    It did cross my mind...but I don't have anything to weld aluminum yet. Still rocking the rubber caps at that location. Should look into those silicone caps hahnmgh63 mentioned above. I go into panic...
  24. Replies
    5
    Views
    1,134

    If you haven't already, the o-rings at the top of...

    If you haven't already, the o-rings at the top of the injector (inserted into the fuel rail) can be replaced also. They are the same as the lowers.

    While you're in there... :D
  25. Replies
    72
    Views
    12,570

    I guess I was referring to the gauge cluster...

    I guess I was referring to the gauge cluster showing "Press clutch pedal to start engine" when the TCU is disconnected. I'd prefer no ABS/ESP with less erratic drive for a short period of time until...
Results 1 to 25 of 367
Page 1 of 15 1 2 3 4