Search:

It is sold.

Boy, I do too.. It's all in the past as bethridg is on his way to take it all.

Sale pending...

More pictures..

https://www.rs6.com/attachment.php?attachmentid=19632&stc=1 https://www.rs6.com/attachment.php?attachmentid=19633&stc=1 https://www.rs6.com/attachment.php?attachmentid=19634&stc=1...

I finally am to the point to of getting all the last Audi parts I have online for sale. I am going to make a for sale thread in classifieds but I want to make a general post about it all here.
I...

I have this Wavetrac that was never installed. It is brand new and never had the seal broken on the box.

I have seen this today online for 1400 to 1500+.

I will sell it for 1000.00 shipped...

So I finally got my car sorted out...kinda. What that means is that I have parted out my car that was turned into a salvage car by the supposed shop storing it in a f&^king shipping container less...

Looks like this is all going to happen in the last couple of weeks in April. My current mechanic is going to get it all organized and together. Paul doesn't want the engine in so that will make...

This has already turned out better than I expected. Paul sounds like a great guy. I can certainly tell he is professional and a real enthusiast! I hope MaxRS6 that we get to meet at some point. ...

Yep, that was my next step. Thanks!

I have spoken to Ohara Automotive. We will be moving forward. They are actually excited about it. I lived for 38 years in Little Rock. So this is good. ...

MaxRS6's PM box is full and can't accept anymore messages until he clears some out. Hopefully someone here has direct communication and will let him know or he sees this.

Thanks for all the advice. I remember MaxRS6. I will reach out to MaxRS6 as well as a couple of the others suggested in PMs. An Arkansas shop rate is substantially less than what I paid Berkeley...

My RS6 project ground to a halt about 5 years ago. The mechanic for various legit reasons....school, new job, health has had good intentions to put it back together but I give up on him.

I am not...

Are these kits ready for ordering? If not, when?

By the way, I am just a few short hours south of you in Arcata, CA.

What about color changes to the caliper. I have red calipers upfront....

I need another wiring harness. I don't really want something that is off of a high mileage east coast car but I know I can't be too picky.

I don't want something that has been cut on or is super...

Do you have the engine wiring harness available? I would need it to be in good condition without cut wires.

Thanks

Sold......

Sold pending payment...should be today or tomorrow.

Sold....assuming I can find the damn cross brace...

I have one for sale. I will have to locate it in a rather large and full storage unit...

http://www.rs6.com/showthread.php/26709-RS6-Fluid-MotorUnion-Intake-System?highlight=

Yes, $700.00 plus fee and shipping.

I don't know what happened to Milka's build...?

I will tell you guys that I would not start this build with hind site. This was one of those rare occasions that I didn't fully research my initial...

I personally have a bit of a hard time with the negativity. How many times can the same people same the same thing at any chance they get. You guys have made your point. Thank you for watching out...

Are these custom made? If so who made them? What is the diameter? I assume that the bulge between the O2 bung and the exit is a cat?