Last attempt to save my JHM rotors..
I was told that turning them will F them up if not done on a proper type of mill.. standard brake rotor turning machine will get the bit fouled up by the slots (or holes) and in turn mess up the rotor itself. Does anyone know the proper name of the machine so I can ask around? someone told me but I forgot.. I think it starts with a B? Blanchard? I am getting very frustrated with this setup (JHM/EBC reds). JHM posits its all the pads fault.. I dont want to toss 1k down the drain in recent rotors.
After doing this I will go with Hawk HPS or stoptech.. thought of EBC yellows, but they left a bad taste in my mouth.
2 Attachment(s)
I guess I'm just cheap...
Attachment 12166Attachment 12165
Got these at O'Reilly. Made by ATE. The same manufacturer as the rear calipers on our cars.
Limited Lifetime Warranty. Very high qualiy. I have driven them hard and have had zero issues. Well, a little squeal sometimes when they're cold and it's wet out.
http://www.ate.de/generator/www/com/.../index_en.html