View Full Version : RS6 Milltek Downpipe Install....m....
Speed Technik
May 14th, 2004, 16:52
In progress:
http://www.speedtechnik.com/DSC02424.JPG
EternalX
May 16th, 2004, 16:56
so how did the install go? Run into any problems? Notice any butt-dyno difference, and is there an upgrade to the software to take advantage of the aftermarket pipes?
Speed Technik
May 19th, 2004, 23:12
Still in process, there are some things that we are dealing with in terms of the install itself. We have had to make some specialy tools for this project. We have also been super swamped and only get an hour or 2 on her per day. FYI, this is not going to be a cheap install.
nyrs6
May 21st, 2004, 16:51
How many Hours do you think the installation will take?
Aronis
May 21st, 2004, 17:29
From the picture you posted and from looking under my own hood I have some suggestions for you guys..
Laparoscopy.
Yes, instead of opening the hood and trying to work in those tight places, drill some holes in the hood and insert laparscopy equipment.
You are down the street from United States Surgical Corporation and they have specialty laparscopy equipment for any operation.
Just kidding of course, be careful of your fingers!
Boy I wish the front bumper opened in hinges....that would make mods easier.
Mike
Why was I being told that to install down pipe you need to lower down the engine?
Aronis
May 22nd, 2004, 20:25
Hell, they build the engine on a bench, test it and then put it in the beast.