View Full Version : Special Tool for Radiator
G2
April 26th, 2017, 17:13
ISO of the 3 prong pin tool for the AT cooler threaded bungs. The bungs are about 2" diameter where the cooler lines plug in.
Likely dealer only, but this is a very resourceful group. Worst case can have one made, might even sell a couple.
See if I can upload a picture...
GreggPDX
April 26th, 2017, 17:38
I've had good luck finding factory tools (knock-offs) at this site:
http://www.samstagsales.com/vwaudi.htm
If you have the tool part number, you should be able to search it there.
G2
April 27th, 2017, 20:19
Thanks for the tip. Didn't see the tool on first glance.
Surprised no one has needed it yet. Plying on it with needle nose or the like makes me concerned.
Bigglezworth
April 28th, 2017, 00:02
ISO of the 3 prong pin tool for the AT cooler threaded bungs. The bungs are about 2" diameter where the cooler lines plug in.
Likely dealer only, but this is a very resourceful group. Worst case can have one made, might even sell a couple.
See if I can upload a picture...photo will help. Are you talking about the secondary remote cooler that includes the oil cooler also, or are you talking about the drivers side bowl?