View Full Version : correct cam phase values ????????????????
RS6 rick
March 1st, 2017, 16:55
Could a fellow member (members) verify -3 to +6 a idle, as being the correct values and are these "new car" or used values? Thanks in advance.
AndyRS6
March 1st, 2017, 17:12
Range from-6 to +6
I think it's not possible to have 0 0 even in new car
RS6 rick
March 1st, 2017, 17:43
Could you please tell me where you got this info ? Thank you very much.
AndyRS6
March 1st, 2017, 20:11
When I did my CCT, I found some info on different audi forum, and was mentioned on this forum to.
From Bentley manual that I found, maybe some one can double check :idea:
17899
Andriy
RS6 rick
March 1st, 2017, 20:35
Now that's good solid info.......thanks so much.
AndyRS6
March 1st, 2017, 21:14
Are you planning to change CCT or just a pads?
RS6 rick
March 1st, 2017, 23:08
Are you planning to change CCT or just a pads?
Took readings last night and they are -2 on pass side and +2 on drivers side. My thought was to just replace pads. Once again thanks.
nubcake
March 2nd, 2017, 00:34
-2 +2 is just perfect! :)
A lot of cars have way worse than that.
I usually aim for +/- 4 between banks and both as close to zero as possible.
RS6 rick
March 2nd, 2017, 01:37
-2 +2 is just perfect! :)
A lot of cars have way worse than that.
I usually aim for +/- 4 between banks and both as close to zero as possible.
Thanks ...my paranoia is gradually fading (-:
AndyRS6
March 2nd, 2017, 02:04
But you know numbers that you referring to are responsible also for timing belt alignment
RS6 rick
March 2nd, 2017, 03:11
I assume you mean the motor is correctly timed. I had not heard the term "timing belt alignment".
AndyRS6
March 2nd, 2017, 03:42
I meant this
17900
RS6 rick
March 2nd, 2017, 06:35
I meant this
17900
Yes that's what I mean.