RS6 rick
February 1st, 2017, 23:31
Could someone post a step by step ab removal, I want to pull my driver side valve cover and don't want to add any first timer mistakes/time wasters. Thanks for any and all help. PMs please. Be safe.
Aronis
February 1st, 2017, 23:44
1. Center from single bolt uses allen wrench
2. bolt on passenger side, 10 mm nut under side, with captivated bolt on frame.
3. bolt on drivers side 10 mm nut and loose bolt.
4. carefully lift up a few inches assembly as you will be popping it out of three rubber grommets (if they are still present)
5. lift a few inches to allow it to clear the metal intake in the rear below the two MAF sensor assemblies.
6. carefully unplug each wire the MAF
7. lift out of the car
Mike
RS6 rick
February 2nd, 2017, 20:06
Thank U !!