Stance off after Koni Yellow install

[Beardown1]

So I did the Koni with stock spring swap and now my stance is off. The front looks the same as before, but the rear is quite a bit lower (I used the lowest perch on the rears.) The passenger rear camber is out of wack too........the top is tilted way in. I suppose I can loosen the control arm bolts and not jack the suspension up so far before I re-tighten them, but can the goofy camber be adjusted with an alignment? Pics below:

1552515526155271552815529

[LIRS6]

rear looks good to me, front a bit of a gap ....

[lswing]

15530Should be like this, not sure though, even after an alignment it's sitting low. Way the springs set into everything I guess?