PDA

View Full Version : FINALLY bought a vag-com from Ross-Tech...



makaveli42
May 22nd, 2013, 19:51
I got it in the mail this morning. Installed it and downloaded the software from the website. I ran my car for faults and all I got was this:

Address 35: Centr. Locks Labels: 4B0-962-258.lbl
Part No: 4B0 962 258 M
Component: Central Lock/Alarm D38
Coding: 15885
Shop #: WSC 00000
VCID: 336B19DB01E48C80ECE


2 Faults Found:
01374 - Alarm triggered by Terminal 15
35-00 - -
01562 - Right Rear Door
59-10 - Can't Unlock - Intermittent


Don't really care about it, but I figured I'd have at least one or two engine fault codes? I have a viper tune and I always hear that ANY tune will throw a few codes. I did this with the car OFF and the key OUT of the ignition. That's how it's done correct?


I'm ready to run some logs now and see how the car is running, ive read the instructions and from on the forum i know to do a 3rd gear pull to redline. But what blocks do I need to run? I couldnt find a list of blocks on the ross-tech site. I feel like my car isnt near as quick as it should be, so Id like to run the boost logs and air temps and i guess anything else that would/could affect the performance.

Also, my air bag light has been on for a week or two, why didnt it throw a code for it?

Thanks!

makaveli42
May 22nd, 2013, 19:52
this was the full sheet, it took a while to do it all but i just wanted to make sure it searched for all the codes, i did the AUTO SCAN mode..

Wednesday,22,May,2013,14:38:04:53732
VCDS Version: Release 11.11.5
Data version: 20121222






--------------------------------------------------------------------------------
--------------------------------------------------------------------------------




Chassis Type: 4B - Audi A6 C5
Scan: 01 02 03 06 08 15 16 17 18 22 34 35 36 37 45 55 56 57 65 67
75 76 77

VIN: WUAPV64B83N905059
-------------------------------------------------------------------------------
Address 01: Engine Labels: 077-907-558-BCY.lbl
Part No: 4D1 907 558
Component: 4.2l V8/5VT G 0002
Coding: 0006752
Shop #: WSC 00000 000 08192
VCID: EBDB41BBC954944064E


No fault code found.
Readiness: 0000 0000


-------------------------------------------------------------------------------
Address 06: Seat Mem. Pass Labels: None
Part No: 4B0 959 760 C
Component: Sitzmemory R1 BF 0205
Coding: 00003
Shop #: WSC 00000
VCID: 2D5F0FA3E7C0DA70BAA


No fault code found.


-------------------------------------------------------------------------------
Address 35: Centr. Locks Labels: 4B0-962-258.lbl
Part No: 4B0 962 258 M
Component: Central Lock/Alarm D38
Coding: 15885
Shop #: WSC 00000
VCID: 336B19DB01E48C80ECE


2 Faults Found:
01374 - Alarm triggered by Terminal 15
35-00 - -
01562 - Right Rear Door
59-10 - Can't Unlock - Intermittent


-------------------------------------------------------------------------------
Address 36: Seat Mem. Drvr Labels: None
Part No: 4B0 959 760 B
Component: Sitzmemory R1 F 0204
Coding: 00001
Shop #: WSC 00000
VCID: 2C5902A7DCDAD378AD4


No fault code found.


End ---------------------------------------------------------------------

lswing
May 22nd, 2013, 20:43
Looks good, i usually have car running when getting data, or key in and power on. Here's my primary list to log. Pick three at a time..

3, timing
31, lambda
112, egt
115, boost

makaveli42
May 22nd, 2013, 20:54
Looks good, i usually have car running when getting data, or key in and power on. Here's my primary list to log. Pick three at a time..

3, timing
31, lambda
112, egt
115, boost

thanks! i did it with the ignition on and it gave me a rear parking senor code and a radio code. So I'd assume my engine/tranny are good?

ill run logs for those blocks hopefully tonight then post my results hopeing someone can read it for me and help me understand lol