Turbo gaskets/o-rings part numbers [Archive] - RS6.com

905084

March 5th, 2013, 17:11

Sending the turbos off to Scroll. Need P/N's for all the little o-rings and gaskets for the water and oil lines. Is there a good source for a parts diagram? I can find some parts, but not all.

Thanks.

ben916

March 5th, 2013, 18:59

I can look at EKTA if you like.
PM sent

mik15

March 6th, 2013, 04:17

here's a list i had it done according to ETKA when i did mine:

<tbody>
077253039C
Exhaust manifold gasket

2

N90778702
Turbo studs

6

4B3253115
Turbo gaskets(turbos to downpipe)

2

078133148E
Turbo gaskets

4

078145039
Turbo gaskets(exhaust manifold to turbos)

2

WHT000039
Nuts

6

077129717R
Intake manifold gasket

2

</tbody>
N 90981601 round seal(oil line) x 2
058145757C gasket(oil line to turbo) x 2

You might as well change most of the O-rings for the water lines including the ones under the intake manifold, the crankshaft seal located between engine and gearbox....you'll see it will take you lot of time and suck a lot of money for these bits, but afterwards you should be ok for another 100k :).

If you don't have ETKA you can use vagcat.com, it's not as detailed as ETKA but still is very good for finding p/n !

905084

March 6th, 2013, 16:47

Thanks both for all the help! I did get on VagCat.com and the turbo diagram is similar to the ETKA. I can't seem to find the cooler line banjo bolts or washers though :/

mik15

March 6th, 2013, 17:54

banjo bolt: WHT 000 223 x 2
turbo nuts: WHT 000 039 x 6
turbo studs: N907 787 02 x 14

all of these are around turbos and should be changed every time you take them out! I am not sure to which washers are you referring to...

905084

March 6th, 2013, 18:47

Finally found it.....under the cooling section not the turbo section of VagCat. P/N N 0138493 for the banjo washers for the coolant lines.

Here is the list of parts I came came up with regarding turbo removal. Thanks for all your help!

 RS6 turbo removal parts list.

Inlet/Compressor side
#34 MAF Seals 077133428 x2
#33 Inlet clamp N10518801 x6
#5 Turbo inlet seal 078133148E x2
Turbine side
#3 Turbo gasket 078145039 x2
#6 Shoulder stud N90778702 x14
#4 Multipoint nut 077145749 x12
#? Nut turbo to downpipe N90200201 x2
#? Turbo to downpipe gasket 4B3253115 x2
Lubrication (oil)
#18 Oil supply banjo washers N0138132 x4
#25 Oil return gasket 058145757C x2
#23 Oil return o-ring N90981601 x2
Cooling
#30 Supply/return banjo washers N 0138493 x4