MNRS6
August 26th, 2012, 16:39
So I was going to remove the alternator to replace the voltage regulator. I was trying to pull the oil cooler lines from the filter housing and I could not believe how hard it was to remove? I was twisting the large nut and the pipe started to collapse. I always had a small leak at the filter housing but now it's worse.
Couple questions:
1. What is the exact size of the oil cooler line nuts? (27mm)
2. What is the best tool to take them off? (Just a wrench?)
3. Am I twisting the wrong nut? See picture, I am twisting the large one, but the pipe seems to twist too.
12892
Couple questions:
1. What is the exact size of the oil cooler line nuts? (27mm)
2. What is the best tool to take them off? (Just a wrench?)
3. Am I twisting the wrong nut? See picture, I am twisting the large one, but the pipe seems to twist too.
12892