Xenon height adjust, vag-com

[lswing]

So after putting on the Koni's and dropping the front and inch or so, my lights aim super low. The adjustment screws are set to high. Went to setting 55 to try and reset, but on level driveway they won't go any higher. I've seen them move up when driving though, so I plan on parking on a decline and tricking the computer to thinking level when setting the on vag-com. My only other idea is to work some sort of shim in...thoughts?

Brights are fine and blow the road away btw....

[Justin9212]

You other option is to cut and adjust the length on the rear ride level sensor to trick the car into thinking it is higher than it really is. It's a job that requires some fabrication skill, but not difficult to do at all.

[4everRS]

I would check the front level sensor. Make sure the bracket is connected to the front lower control arm between the knobs like it should be.

It is on the drivers side. Turn the wheel all the way to the left and get low to the ground looking from the front, back towards the axel. You may have already known this. Just wanted to clarify.