Part numbers?

[Cochese]

Hi all.

I need to replace the fog light lenses (they are pitted all to hell) and I need some "clips" for the driver side door trim (where the blades would be on an allroad).

Is there anywhere online that has these for sale or a part number repository so I can avoid the stealership?

Thanks!

[lswing]

I was looking at ETKA, so fog lights themselves, yes? The door trim below the thin strip?

[Cochese]

Well, the fog light housings are fine. The glass lenses themselves are what need to be replaced. I'm not sure if they are two pieces or if I have to order the entire fog lamp assy just to replace the lens. If that's the case, I will just toss a Lamin-X film on there and not worry about it. I'm sure they are hundreds of dollars.

The trim is the thin (1 inch approximately) piece on the lower quarter of the doors. It is painted body color. Mine is on there but it isn't secure because several clips are broken or missing.

Here she blows:

https://lh4.googleusercontent.com/-ggbMWGCIZJM/TwgC6bIGUtI/AAAAAAAAD00/GUIYqJ6bDO0/s512/IMG_20120104_163051.jpg

[PatrickR]

http://img805.imageshack.us/img805/7255/foglightsrs6.png

Is this what you need? Note: I looked it up using my own chassis number, EU car ...

[PatrickR]

The part number for the clamps holding the trim on the door are unknown in ETKA. They appear in the pictures (11), but without part number..

http://img546.imageshack.us/img546/4172/doortrim.png

[Cochese]

Thank you for those. It appears I need to replace the entire housing. HELLA appears to offer some alternatives as well but they are $150-175 a piece. I wish the lenses alone were available. Oh well.

I may try and call the stealership for those clips if nobody else has a line on them.

[Jimmy]

Right, unfortunately, all C5 foglites are sold as complete 'units'.

You can tho....take out the units, polish the lenses with like a 3M headlite resto kit, lamin-x them (yes, they sell the fogs alone) for pretty cheap bucks. BTDT with the allroad fogs.

I'm not 100% sure that the Rs6s are different, but lower moulding clips from any C5 may work...call a junker like Shokan for used ones.