View Full Version : MAF assembly outer diameter
terrytcl
November 17th, 2011, 17:09
Can someone please confirm for me the OD of the MAF assembly housing? Is it 3.5"?
melsas
November 17th, 2011, 20:36
Are you going to fab up an intake?
speedtrapped
November 17th, 2011, 20:46
was wondering that myself
terrytcl
November 17th, 2011, 21:21
yes, but i'm trying to first figure how to better seal against the OEM ring seal.
hahnmgh63
November 18th, 2011, 01:20
11952#1 is 3.13" & #2 is 3.15" so with manufacturing tolerances they are probably the same.
terrytcl
November 18th, 2011, 15:36
thanks mark.
i'm looking at trying out a tapered gasket that will wedge itself between the stock gasket and the MAF body.
i'll let everyone know how well it works. also, going to try and see if there's a way to bolt down the maf to the inlet bodies so that there's no leak for aftermarket intake systems.
speedtrapped
November 18th, 2011, 16:00
Kudo's Terry....If there is a better way, I'm in. The damn MAF seals lose a little bit of life everytime the housings are removed, its a horrible design, not to mention the rings are a small fortune for rubber/steel.
terrytcl
November 18th, 2011, 19:43
i'll try to have a solution before the end of the year.
i also want to start fabing up some simple intake kits. nothing flashy -just functional :)
looking to also start putting together an exhaust kit without mufflers. let you guys decide on the mufflers you want
JSRS6
November 18th, 2011, 23:04
Definitely let me know about the exhaust. I am gonna need some 4" cat-less dp's that will mate up to gt2871's. And I want 4" all the way back to modified milltek tips.