View Full Version : Anyone have a set of the MTM stronger intake bushing kit? How the hell do you fit it
hahnmgh63
July 19th, 2011, 03:47
11545The I.D. of the bushings are 98mm and seem to be too big to fit over the MAF's which are a fair amount smaller?
marklar182
July 19th, 2011, 04:29
They go in the intake tubes, pre airbox.
hahnmgh63
July 19th, 2011, 04:35
Thanks, but how are these suppose to help? I thought I was ordering the extra rubber bushings that help seal the MAF's better.
yokust
July 19th, 2011, 06:36
They are just to keep the plastic from crushing under the hose clamp, so the stuff looks flawless all the time
hahnmgh63
July 19th, 2011, 14:29
Well crap. Since those hoses are just on the air intake I have already removed the clamps and are not even running them. Somebody on the list here had some extra rubber bushings around where the MAF's slid into the aluminum intake tubes at the back of the engine and they thought they had determined that they were from MTM so that is what I thought I was ordering. Just some insurance that I wouldn't get a MAF air leak although I am replacing those little $65 metal reinforced intake O-ring jems that Audi is very proud of.