PDA

View Full Version : Name that problem



Brav
June 10th, 2011, 18:29
I figured you guys were bored, so I will post some fault codes I got recently. A few weeks ago I got CEL with a P2098, which was for "post catalyst fuel trim system too lean". In 2 months before that in April, I had these:

Address 01: Engine Labels: 077-907-558-BCY.lbl
Part No: 4D1 907 558 D
Component: 4.2l V8/5VT G 0003
Coding: 0006752
Shop #: WSC 02195 785 00200
VCID: 2F67E54FC78D

2 Faults Found:
17865 - Exhaust Gas Temp Sensor 2 (G236): Open or Short to Plus
P1457 - 001 - Upper Limit Exceeded - Intermittent
17585 - Bank2: O2 (Lambda) Correction Behind Catalyst: Control Limit Reached
P1177 - 001 - Upper Limit Exceeded - MIL ON
Readiness: 0000 0000

I cleared the above, and they never came back.


Recently, the traction control light has come on twice, then went away. Cleared it and hasn't come back yet.

I had 2 instances that I recall where the car will lose power for about 1 second under normal driving, right around a shift point. Then she carries on like nothing else. I almost crapped when I saw Auto Trans fault, but looks like bad sensor/brake switch? I have had the gear selector switch come up 3 times now.

I have had the low emergency battery one for a while, do I need to replace it?

Current codes:

Chassis Type: 4B - Audi A6 C5
Scan: 01 02 03 06 08 15 16 17 18 22 34 35 36 37 45 55 56 57 65 67
75 76 77

VIN: WUAPV64B03N905315
-------------------------------------------------------------------------------
Address 01: Engine Labels: 077-907-558-BCY.lbl
Part No: 4D1 907 558 D
Component: 4.2l V8/5VT G 0003
Coding: 0006752
Shop #: WSC 02195 785 00200
VCID: 2F67E54FC78D

No fault code found.
Readiness: 0000 0000

-------------------------------------------------------------------------------
Address 02: Auto Trans Labels: 01L-927-156.lbl
Part No: 4B0 927 156 FL
Component: AG5 01L 4.2l5VT USA 0305
Coding: 0000002
Shop #: WSC 02195 785 00200
VCID: 76E9102B7857

1 Fault Found:
17087 - Brake Switch (F): Electrical Malfunction
P0703 - 003 - Mechanical Failure - Intermittent

-------------------------------------------------------------------------------
Address 03: ABS Brakes Labels: 4B0-614-517.lbl
Part No: 4B0 614 517 AD
Component: ESP 5.7 RS 6 2310
Coding: 06697
Shop #: WSC 02195
VCID: 63CF597FDBC5

2 Faults Found:
01119 - Gear Recognition Signal
35-10 - - - Intermittent
00526 - Brake Light Switch-F
27-10 - Implausible Signal - Intermittent
-------------------------------------------------------------------------------
Address 75: Telematics Labels: None
Part No SW: 8E0 035 616 A HW: 8E0 035 616 A
Component: Telematik USA1
Coding: 0002033
Shop #: WSC 22197 444 58726
VCID: 234F197F9B45

1 Fault Found:
01531 - Emergency Battery
002 - Lower Limit Exceeded - MIL ON

speedtrapped
June 10th, 2011, 18:40
p0703-003....had that as well, Tozo solved the issue, my ABS sensor needed to be removed and cleaned...pretty easy to do...the other telematics is the crappy onstar...wouldnt worry about it

ben916
June 10th, 2011, 18:54
O/T:

added - VIN: WUAPV64B03N905315

Brav
June 10th, 2011, 18:55
Thanks. Where is that thing located?

speedtrapped
June 10th, 2011, 19:34
abs sensor? take wheel off, behind dust plate, on the axle, one bolt holds it in, remove...spray w/ black cleaner wipe, and reisntall...also check wiring from sensor to body

speedtrapped
June 10th, 2011, 19:35
there are 4, i just did my 2 front

JSRS6
June 10th, 2011, 19:55
abs sensor? take wheel off, behind dust plate, on the axle, one bolt holds it in, remove...spray w/ black cleaner wipe, and reisntall...also check wiring from sensor to body

Look at this guy^^^^ :hihi:

speedtrapped
June 10th, 2011, 20:00
I'mmmmmmmmm smaaaattttt....I can do tings...mike ya never gave me a chance...

JSRS6
June 10th, 2011, 20:03
I'mmmmmmmmm smaaaattttt....I can do tings...mike ya never gave me a chance...

:lovl::lovl::lovl::lovl::lovl::lovl::lovl:

ben916
June 10th, 2011, 21:01
i'mmmmmmmmm smaaaattttt....i can do tings...mike ya never gave me a chance...

lmao 12345678

hahnmgh63
June 11th, 2011, 00:17
Every time I do a brake job on my cars I remove the ABS sensors & clean them, they are magnetic so somethings stick to them pretty good like metallic brake/rotor dust.