View Full Version : Removing front door switch bezel, how to do it?
I finally got sick of the soft plastic pealing on my driverside window switches and bought a new bezel, but not sure how to put in. Any advice?
Thanks! :rs6kiss:
DHall1
June 3rd, 2009, 04:35
Mine is just starting to peel.
How much and part number?
Sorry, I have not pulled mine yet but having the info should help others.
DuckWingDuck
June 3rd, 2009, 04:36
just buy a new door!! haha. I think someone has the instruction manual and can post the instructions?
Ill post the pn in a bit. Cost was $27.00
DuckWingDuck
June 3rd, 2009, 04:42
you're talking about the little piece of plastic trim that goes around the window controls right?
you're talking about the little piece of plastic trim that goes around the window controls right?
That would be it!
DuckWingDuck
June 3rd, 2009, 05:30
ya, don't quote me on this because I don't really know but I bet that it's like all the other trim pieces, you just pop that bad boy off. Anyway, mine is all scratched up too.
mmaturo
June 3rd, 2009, 05:48
ya, don't quote me on this because I don't really know but I bet that it's like all the other trim pieces, you just pop that bad boy off. Anyway, mine is all scratched up too.
It appears to just pry off...I can tell as i had one of the rear window switches replaced recently in that group and there is the left behind mark of the tool badly used to pry it up.
DuckWingDuck
June 3rd, 2009, 06:06
It appears to just pry off...I can tell as i had one of the rear window switches replaced recently in that group and there is the left behind mark of the tool badly used to pry it up.
Ouch. that's effed up!
Ok, part number is 4B1-959-521-7PE for Onix, which I think every RS6 has, correct me if I'm wrong.
mmaturo
June 3rd, 2009, 16:49
Ouch. that's effed up!
My car seems to be the Rodney Dangerfield of RS6s.