Activity Stream

Yes, the rubber around the outside edges. CW

When I took the original headlights apart, I just picked up any clear silicone sealant and that was enough to keep them dry inside. Or... are you...

You do not need to remove the rear coolant line bolt to get the valve cover off. You only need to remove the front one and the pipe can flex enough...

All of this work just to get a bolt out to be able to replace the valve cover gasket.

I don't think you can get at it from underneath, maybe with a 6spd conversion. What you might do is lower the whole subframe. I'd loosen the front...

Does anyone k know if it's possible to reach the rear coolant pipe bolt from under the car? I can't get a good photo of it with my phone to be 100%...

No that I think about it all 4 of mine were Allen bolts.

Yeah, the bolt closer to the firewall. I have a solution and I should have it out tomorrow. Also, I put a camera down there and it's a T-40 torx...

Maybe a ball socket Allen so you can still get in there at a slight angle, I'm assuming the one you are having a problem with is the inner bolt.

I am having a hell of a time getting the rear 5mm allen head bolt out from the back side of the passenger coolant pipe. I can't get anything to fit...

Do you still have it?

Thanks for the info! Yea that’s a pain they’ve clamped down on you.

It's a simple process. Both the High & Low ports are easy to get at. Good thing you're across the border, WA state Gestapo just made R-134a...

Thank you so much Nubcake. It was a f'n used rag that fell into the pass side charge pipe.

Can't wait to see it!!!

Rotors and Pads SOLD!!

First thing I did was only KRKTE, with no affect on drivability and O2 sensor voltages remained high. It's possible there's rags. I'll scope it to...

Also, you have A LOT of vacuum in the charge pipe (!!!) under WOT. Forgot rags in the intake piping or something?

You didn't mention you were messing with the tune. Revert LAMFA. Stop doing what you don't really understand.

Alright, I got the sensor replaced and still don't have any power past 1/4 throttle. Note for future reference, I pulled the axle and heat shield...

SOLD!!! Picked it up yesterday.

Update...RS6 TCU Sold... Still available: Aux radiators & hoses 2 Auto transmissions with torque converters Auto starter

It is sold.

Boy, I do too.. It's all in the past as bethridg is on his way to take it all.

Damn it I missed the part where it was Scotty that let this happen and part of the service centered around the 6spd conversion. Wish you would have...

Sale pending...

Sent you a PM

Update.... TDI 01E, Stern mounts, QuickJacks, shift knob, Miltek rear cans, and Raxles all sold.... Still have: Aux radiators and pipes/hoses...