So I went ahead and filled the car up with coolant BEFORE I connected everything this time. Sure enough there was a leak... Passenger side turbo coolant feed at the bango bolt. Talk about inaccessible... I had to cut down my 19mm wrench, reach up over the driver side of the transmission and over to the passenger side just to get an angle on it. She's tight now. Filled it up with coolant, let the thermostat open; she's fully bled (No, not that kind). With that I did a nice little break in rev which is at the end of the Youtube video. HOLY SH*T! These Chinese Spinyboyz spool like there's no tomorrow!


Too tired to continue so I'll pick up tomorrow, and hopefully get it on the ground and rolling under its own powa.





Here's that wrench I was talking about haha.


20190417_123555 by Joel Francisco
20190417_123612 by Joel Francisco