i literally just took out my TCU 5 mins ago! it was actually pretty damn easy!!!
1. move the passenger seat to the back
2. use a flat head and remove the tiny trim cover on the passenger side kick panel
3. use a philips (+) screw driver and take out the two screws on the passenger side kick panel.
4. pull the passenger side kick panel out, remember, where it meets the door sill, there is one clip attached to it... use some effort there.
5. yank out the door sill till the b-pillar (u dun need to take out the whole thing, but make sure u dont accidentally push the seat adjustment buttons)
6. stick your hand in and remove the TCU box from the holder!
didn't have to remove glove box... took me approx 3 mins to take the TCU out!
Adding photos to help this thread...also fairly obvious but wanted to mention the croc clasp that holds the TCU to the connector pin its somewhat intuitive but no one made mention of it don't thinkso anyway
Current: Black Pearl Metallic Effect/Ebony, RNS-E, Euro + pedals, oCarbon, Hotchkiss Front & Rear Sway Bars, Koni Yellow's
Adding photos to help this thread...also fairly obvious but wanted to mention the croc clasp that holds the TCU to the connector pin
I just got my TCU Back and tried but could not figure out how to get the Clasp and connector pins back together can someone advise if possible, I don't wanna break this thing after sending it all the way to Canada to get the MTM. Insight appreciated.
Thanks in advance!
Current: Black Pearl Metallic Effect/Ebony, RNS-E, Euro + pedals, oCarbon, Hotchkiss Front & Rear Sway Bars, Koni Yellow's