-
August 25th, 2016, 19:13
#1
Registered User
RS6 Engine Mounts for Manual Trans
Just completed a manual trans swap on my RS6 Avant. I get a lot of driveline judder upon clutch engagement. This is during a light pull away not a drag type launch.
Anyone know of some heavy duty motor / trans mounts that can calm this down ?
Anyone experienced this on an 01E install ?
Any other suggestions to a remedy other than requiring less compliant mounts?
Rick
-
August 25th, 2016, 21:33
#2
Registered User
Ceramic clutch? It will gradually do that less as the clutch breaks in.
-
August 25th, 2016, 23:25
#3
Registered User
It has an organic disc in it. Hard to define in words but this is not clutch chatter as much as driveline judder.
-
August 28th, 2016, 14:59
#4
Registered User
did Nubcake do the file for you? He made mine much better about this. Mine does it also it's like there is play in the driveshaft or something and it will jerk or judder with the engine trying to keep the same rpm yes the trans/drive shaft will slow and catch, slow and catch. Some of this may be the file you are using. Daz had not been able to finish my file but Nubcake fixed 50% of this issue just through tuning.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules