Flat tire.
Thinking 275's all around...may go to a 35 up from the seemingly unforgiving 30.
Didn't hit too hard, hoping I don't need to repair a wheel as well.
Flat tire.
Thinking 275's all around...may go to a 35 up from the seemingly unforgiving 30.
Didn't hit too hard, hoping I don't need to repair a wheel as well.
Bummer...stock size on 18" wheels seems to have plenty of padding, although that will vary by tire. I know the Michelin PSS's have a VERY sturdy sidewall.
Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com
I think there are issues (documented on this site) going to 35's with 19's. I think that is why MTM recommends 30's for their Bimotos (which I used to have and used to run). Despite looks I went back to 18's for this exact pothole reason.
RS6 #1 904959, Daytona, Silver, tons of "stuff," went through puddle, dead engine, end of #1 for me, rebuilt by local enthusiast and thriving.
RS6 #2 904568, Avus, Ebony, no stuff, stock minus RNS-E.
No issues with that size here, it's using the PSS tires
BB GT28's w/ Tial Wastegates, Full 3" Open Exhaust, Wagners, Billet Triple Disk Converter, Built Trans, Exedy Friction Disks, ECU/TCU Tuned, 450/AEM400/1000cc/AFPR, E85, R8 Coils, Nubcake Tuned. Fastest RS6 in the USA :)
255 35 19 pss
No issues
Im not a fan of 30s on the C5
PSSssssst...I think I know the answer. Plus no flat spotting when your car sits for a week.
Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com
Whew! It's all done.
Toyo T1S (I got a ridiculous deal from my tire guy) 275/30/20. Better protection all around.
As I previously posted, I'm running Sportec Mono 10's (forged)...fortunately no wheel damage...thankfully forged instead of cast.
I'm not sure if the spacers I ordered from ECS will be necessary (or even work (15mm/20mm)) but I'll find out when they get here.