Results 1 to 18 of 102

Thread: Survey; When did your cam adjuster/tensioner(s) fail?

Threaded View

  1. #1
    Registered User lswing's Avatar
    Join Date
    May 2011
    Location
    Eugene, OR, again...
    Posts
    4,760

    Mech Survey; When did your cam adjuster/tensioner(s) fail?

    Just wanting to log this as it seems to be up there in the costly repair category, and a buyer should be aware this will happen around/after 100k.

    Rough idle and flashing CEL on startup; upon scan the driver engine bank 5, 6, 7, 8 was mis-firing. Upon scanning measuring blocks (70 & 72?), the cam adjuster on driver side was reading -7 (not working), while the other reading 16 (working).

    So mine went, plastic roller for chain completely shattered on drivers side, at 98k. So far no other damage that we know of, and will also be replacing passenger side (which is a pain).

    Here's my updated list, will keep adding to it. Who else has changed this lovely $650-850 part, times two?

    Hey, if every part on this car lasted 100k miles I'd be happy!

    MaxRS6
    Cam adjuster went out at 95K.

    lswing
    Drivers side cam adjuster disintegrated at 98k, passenger worn but replaced also.

    fbatwork
    Replaced at 65k, mostly worn, 25% left on plastic guides.


    Last edited by lswing; September 29th, 2014 at 20:04.
    Ace/Edge TC - Tozo Trans - MTM TCU - REVO/ME7 tune - Wagner IC's w/ Venair Hoses - Aux Radiator delete - Hotchkis Sways - Hawk HPS Pads - Koni Sport Struts - Scroll KO4 Turbos - Devil's Own WM - 421whp/452wtq on Mustang Dyno - http://www.audirssix.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •