^Mark me down as jealous...;(
Good luck with getting it resolved- That's all I have to offer...;0
^Mark me down as jealous...;(
Good luck with getting it resolved- That's all I have to offer...;0
210K miles rolled
Randy^^^ TYVM.....i have read that basically i can buy 4.7 ohm resistor from the shack, and bridge the connector which will resolve issue. There are 4 connectors under seat, 2 of which have multiple connections, 2 with only 2....i of those 2 is all black, power to seat motor.... so is the yellow connector with 2 plugs is the airbag harness?....
Ebony/Black, DBR Stage 3 race kit, -SOLD :( 996TT Proto 650 basically a sardine can with a rocket attached to the back...11' CTS-V, 540/579RWP hehehehe ;)
Sounds like a DIY with photos!!!!
SOLD - 03 RS6 Avus (905355)
Current - 03 Toyota Tacoma 4x4 double cab - the YETI, lifted, winched, snorkeled, lockered, skidded, geared
yah, it sure does
Ebony/Black, DBR Stage 3 race kit, -SOLD :( 996TT Proto 650 basically a sardine can with a rocket attached to the back...11' CTS-V, 540/579RWP hehehehe ;)
I was perusing ebay.de looking for seats and found these. It says they are for A4, S4, RS4, maybe they would fit your harness. The seller has a couple different connector types, maybe if you email him, something could be made.
http://www.ebay.com/itm/Airbag-Seite...item43ac6de291
Thank you for the link.
Ebony/Black, DBR Stage 3 race kit, -SOLD :( 996TT Proto 650 basically a sardine can with a rocket attached to the back...11' CTS-V, 540/579RWP hehehehe ;)
What does the the front seats have to do with the airbags? Front seats have no air bag in them...or do they? I think your problem is the front seats belts. Did you connect the connector for the front seat belts? I have a complete set of EU recaros in my car and when I installed them I forgot one of the connectors under the front chairs ( I think it might have been the seat belt one) because I was too anxious to drive in them. Connected it, cleared code and everything is fine. Good luck!
I am reviving this thread because what do I do when my seat motor seems to be toast!? So I can't move the seat all the way back. The seat is in about a middle position right now.
You hear it click when you move a button and then nothing, like the control panel is sending signal to a dead motor. Does the motor have a separate fuse? Should I check that?
RS6 #1 904959, Daytona, Silver, tons of "stuff," went through puddle, dead engine, end of #1 for me, rebuilt by local enthusiast and thriving.
RS6 #2 904568, Avus, Ebony, no stuff, stock minus RNS-E.
Any help here?
RS6 #1 904959, Daytona, Silver, tons of "stuff," went through puddle, dead engine, end of #1 for me, rebuilt by local enthusiast and thriving.
RS6 #2 904568, Avus, Ebony, no stuff, stock minus RNS-E.