So I decided to take a look at the MAF seals my mechanic installed, in additon to other work. well I am not flaming a vendor, because Doug was nice enough to give me a set free. when I was removing my maf housing I notice the seal was 1/2 popped out, upon lifting on the housing the seal stuck to the housing and slipped right out. I pulled it off and inspected it as i had not had it in my hand prior. They are squishy, there is no metal ring in them. I placed on in the inlet and it slid right in, but it pulls right out..bummer.
so i decided to attempt something, as the material will never wear llike the rubber. i cleaned the inlet lip, and cleaned the seal. I took 4 drops of super glue and carefully placed the seal back in, bingo..not budging.
now for the good news, the seals thickness is beefy, as I have been testing logs between stock box and DBR CAI it took some hard pushing down to get them in, with stock box the mafs are tight as t..., well u know. Actually 1st time I did it, I did not have maf driver side all the way in, started it and stuttere stall. after realizing i had NOT had driver side seated all the way in, pushed hard the maf seated, they do NOT budge.
I am going to keep them.....