They are, right? Not front and rear bumpers, but door skins, fenders, quarter panels.
4.2 fenders and hood are aluminum, und not schteel, correct?
They are, right? Not front and rear bumpers, but door skins, fenders, quarter panels.
4.2 fenders and hood are aluminum, und not schteel, correct?
Yes on all that...rocker covers are Rs6 specific tho too, you knew that.
Are the front fenders aluminum too? I thought just the hood on the RS6. Must check that.
SOLD ! 2003 RS6 Mugello/Silver -MTM
2001 allroad 6-speed (300K+), 1992 Mercedes-Benz 500E, 2007 Mercedes-Benz CLK63, 2010 BMW X3, 1986 16V Scirocco, 2005 Mercedes E55 Wagon
Hood and front fenders are aluminum on both.
Avus RS 6, RNS-E/BT/RVC, Eurocharged/MTM, SuperSports, PSS9/Hotchkis, SS Lines/EBC Reds, FMU/BMC, Sportec vents, 007's, 9500ci, Black Optics/Headlights/Trim/Rims, CC; coming soon: stage 3 snow meth
Thanks men. As I thought. I have a line on some salvage 4.2 bits that will allow me to repair the destruction some anonymous fool inflicted on my fender in the parking garage, and realize my heat extraction hood vent fantasies without chopping up my baby's bonnet.
planning to do a bonnet like the World Challenge RS6 race car? I've entertained vague thoughts of doing a replica (bodywork, not the livery) of the race car. One version had massively widened fenders, but most were essentially stock with bodywork, except the adjustable front spoiler, rear wing, and hood vents. Well, cutouts in the headlights for air intakes as well, but that's going a bit far :P
Das Silberkugel - Eurocharged Stage 2/MTM/Level 10/Hotchkis/Koni/H&R
2015 Ducati 1299S Panigale
2014 Ducati Multistrada Granturismo
Yes all the main metal is same as 4.2. Hood, front fenders are Aluminum for sure
Lots of aftermarket companies make steel fenders for the 4.2, they dont list they fit RS6 but they do obviously they do. I have even seen them on RS6 after a wreck.