Quote Originally Posted by Avus-RS6 View Post
Got the DRC and H&R Race springs installed this weekend, thanks Dave for the low mile DRC, it was super clean upon arrival! Thanks Jake for helping all day Sunday. It would have sucked to do that without a lift, and an extra set of hands (and your shop manual for torque specs) and your confidence to tackle the job.

Car is about 1.5 inches lower than before (measured front after dropping from the lift). I'll post up final measurement results front and rear after I get the car back from the dealer for its DRC recharge. So excited to have a non rattling RS6, one that handles as it was meant to once again!

Damn! I needed schooling on this one!!! Please PM or email or contact next time...