Search:

Type: Posts; User: essexmetal

Page 1 of 3 1 2 3

Search: Search took 0.03 seconds.

  1. For Sale 2003 RS6 Euro Avant, 17K Miles 6 speed Manual

    2003 Euro Spec RS Avant. Under 17,000 miles. 6 Speed with trans oil pump / cooler, Upgraded turbos, ECU upgrade, Wagner Intercoolers. Stock springs but DRC removed with sport Konis. Swaybar upgrade....
  2. Replies
    0
    Views
    796

    2002 S6 For Sale

    If anyone is looking for an S6 Avant for parts or conversion I have a 165K Mile one that will be going to a new home. It has rust through on the passenger door, and some rust flaking on the rear...
  3. Replies
    9
    Views
    2,446

    As the mileage shows it spends most of its life...

    As the mileage shows it spends most of its life parked. I bought it with 12800 miles on it 4 years ago. It is super nice but far from collector grade, Q tip clean. I have noted before that short of...
  4. Replies
    9
    Views
    2,446

    Not sure if that price is a bit tongue in cheek....

    Not sure if that price is a bit tongue in cheek. Granted it has a US title but I was figuring a reality price would be $20K to $25K lower. Hard to know where the market lies since so few are out...
  5. Replies
    9
    Views
    2,446

    RS6 Avant Price Check

    Looking to the forum for a price check on a 2003 RS6 Avant. This is an original car, not a conversion. Car has only 15k miles.

    Replaced DRC, upgraded turbos and ECU, and a fresh manual trans...
  6. Replies
    2
    Views
    1,680

    RS6 Manual Avant

    After a year of “ not in a hurry to get it assembled” the power train is going back in the RS6 6Speed. The car was together and running sweet accept for the fresh rebuilt trans which had some major...
  7. Replies
    28
    Views
    139,563

    Dave, great buy. I know you will enjoy every mile...

    Dave, great buy. I know you will enjoy every mile in the RS6 when not putting hours in with the RS2.

    I have a 2003 RS6 Avant that I just don't drive enough. Now with winter descending on Michigan...
  8. Replies
    17
    Views
    5,493

    Well there will be one low mile Avant at the rate...

    Well there will be one low mile Avant at the rate I am going to getting mine back on the road. It has 15K miles on it. Bought it with almost 13K, so not too much per year goes on it. Roads are such...
  9. Replies
    17
    Views
    5,493

    Yes "S" Guy. After going through the trans I...

    Yes "S" Guy. After going through the trans I would like to think it was just real poor workmanship or an error rather than intentionally setting out to screw someone. Either way has the same result,...
  10. Replies
    17
    Views
    5,493

    2003 RS6 Avant

    With the talk about RS6 Avants on the suspension post I thought I would note that one more is about to get back on the road. I had done a manual conversion to my Avant a couple years back....
  11. If you are looking to resurface the rotors check...

    If you are looking to resurface the rotors check in your area for an engine rebuilder with a flywheel grinder. Grinding has several advantages over turning.
    Unlike turning which suffers when it...
  12. Replies
    5
    Views
    2,255

    PRNDL Delete After Manual Swap

    Has anyone who has done a manual swap found an easy way to delete the PRNDL lights. I have not asked my tuner yet, thought I would check with the group first.
  13. Replies
    2
    Views
    1,614

    Avant Manual Trans Swap Completed

    A while back I posted about some clutch judder issue on the 6 Speed manual installation in my Avant. Someone commented that he had some of the same issue which was resolved when the engine tune was...
  14. Replies
    3
    Views
    1,681

    It has an organic disc in it. Hard to define in...

    It has an organic disc in it. Hard to define in words but this is not clutch chatter as much as driveline judder.
  15. Replies
    3
    Views
    1,681

    RS6 Engine Mounts for Manual Trans

    Just completed a manual trans swap on my RS6 Avant. I get a lot of driveline judder upon clutch engagement. This is during a light pull away not a drag type launch.

    Anyone know of some heavy duty...
  16. Replies
    3
    Views
    1,405

    Sorry..... Idris Elba Land Speed

    Sorry..... Idris Elba Land Speed
  17. Replies
    3
    Views
    1,405

    RS6 Avant on TV

    Bit late but just watching it now. There is quite a bit of coverage of Idris Elba trying to break the land speed record at Pendine Sands. He starts with modifying an RS6 but finally goes to a Bentley...
  18. Replies
    2
    Views
    1,429

    Bigglezworth, thanks for the reply. A shop manual...

    Bigglezworth, thanks for the reply. A shop manual and Google mimicked the info you supplied. The new center bearing was bent which triggered the question before I called the company that supplied the...
  19. Replies
    2
    Views
    1,429

    RS6 Driveshaft Center Bearing

    Can anyone confirm that the RS6 Center Bearing is supposed to be offset off of the center line approximately 19mm towards the passenger side?

    I can see this could be done to keep the center U...
  20. Replies
    9
    Views
    2,467

    I like the USP even better than the ECS lines...

    I like the USP even better than the ECS lines based on the rear banjo fittings are a block style which restricts rotation, just like stock. The regular (round) banjo fitting requires some form or...
  21. Replies
    9
    Views
    2,467

    Aronis, SH*T I deal with ESC on other car parts...

    Aronis, SH*T I deal with ESC on other car parts and never thought to look there. The lines never came up on the google search. Thank You !!!! Your link has saved me a ton of time.

    Last thing...
  22. Replies
    9
    Views
    2,467

    Uprated Brake Lines

    Has anyone found an aftermarket DOT Stainless brakeline kit for an RS6. The one company I have ordered from have sent the wrong set a couple of times. Need to explore a new source.

    Thanks
    Rick
  23. Replies
    2
    Views
    1,936

    Rotor Reconditioning

    Let me start by saying, there is nothing like new. But even at the wholesale pricing I get I was not going to drop that much on new rotors for the RS6. Pull off a day at the track or a week on the...
  24. Replies
    5
    Views
    3,621

    WTB RS6 OIl Cooler Shroud

    Does anyone have a surplus shroud for the oil cooler? Plastic part that helps duct air into the engine oil cooler. Mine has some chunks missing out of it and thinking that there are a few members...
  25. Replies
    4
    Views
    2,240

    Steve, The S8 motor was a 40 valve. I broke a...

    Steve, The S8 motor was a 40 valve. I broke a belt and and was replaced at my buddies shop with another motor. He had the blown motor in the back and offered it up as a mock up. Don't know the...
Results 1 to 25 of 60
Page 1 of 3 1 2 3