Search:

Type: Posts; User: Brav

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds; generated 26 minute(s) ago.

  1. Replies
    24
    Views
    7,008

    Car looks good. Get some spacers to push the...

    Car looks good. Get some spacers to push the wheel face to the edge of the fenders, 5-7mm, and it will look great. Also, get longer wheel bolts.
  2. Replies
    13
    Views
    3,950

    Sounds like its on its way out. I would...

    Sounds like its on its way out. I would replace.. I noticed my voltage dropping in high heat before it went out all the way.
  3. Replies
    327
    Views
    136,464

    I dont have it but I may mention it in that...

    I dont have it but I may mention it in that thread.. I bought the relocation kit but just used the pump out of it. Doesn't relocate for RS6.. at least not with the stock Audi kit
  4. Replies
    327
    Views
    136,464

    90% SJP. I had fun doing that job....

    90% SJP. I had fun doing that job....
  5. For what its worth, it may be convenient to have...

    For what its worth, it may be convenient to have the solar panel/air recirc for you, but I doubt it makes a huge difference. On the engine side, I ripped out the entire secondary radiator plumbing...
  6. 15k Federalization - through which importer? I...

    15k Federalization - through which importer? I have considered doing this. I know G&K did many Ferraris, don't know who did the RS6s.
  7. Thread: Mobil1 5w40

    by Brav
    Replies
    34
    Views
    16,306

    I've used it in other turbo Audi's before, lot of...

    I've used it in other turbo Audi's before, lot of the A4/S4 guys like it too. Still prefer the M1 0W40 Euro spec over it. For RS6, BND or Motul for my car.
  8. Replies
    4
    Views
    5,979

    Same happened here. Bad fan for me. But yes check...

    Same happened here. Bad fan for me. But yes check refrigerant. Can use vagcom I believe to check pressure quickly. See if both front fans come on?
  9. Replies
    22
    Views
    23,687

    I don't own one but have driven one. Felt like a...

    I don't own one but have driven one. Felt like a different car. 100% way to go.
  10. Replies
    11
    Views
    11,659

    center drive shaft (carrier bearing), or control...

    center drive shaft (carrier bearing), or control arm bushings, as mentioned. I ended up replacing both.
  11. Put better tires on there than Hankooks!! :D

    Put better tires on there than Hankooks!! :D
  12. Replies
    18
    Views
    12,658

    I also wont run the Hankooks anymore. They are...

    I also wont run the Hankooks anymore. They are OK for a lighter car, but mine got destroyed as well and same problems as Ben. They wore quite fast as well
  13. Thread: S6 Advice Needed

    by Brav
    Replies
    6
    Views
    2,674

    Would save for the S6 4.0T, or get the A6 3.0T...

    Would save for the S6 4.0T, or get the A6 3.0T and chip it. Those things are fast.. and probably more nimble than the V10.
  14. Replies
    21
    Views
    11,146

    ^ what he said. don't do it until you start...

    ^ what he said. don't do it until you start getting codes, or major gear slamming. I think it got me another 6 mos.
  15. Replies
    20
    Views
    7,518

    #Twinning!! jealous..

    #Twinning!! jealous..
  16. Replies
    34
    Views
    20,720

    Yes, check the filter. I had to trim mine. Also,...

    Yes, check the filter. I had to trim mine. Also, still had to refill after one week of driving as well. Should be fine after checking these two things.
  17. Might be able to do something for you, but not...

    Might be able to do something for you, but not for another month or so. Will get back to you if you still have it then.
  18. Thread: 905593 repairs

    by Brav
    Replies
    40
    Views
    20,726

    From what I see, ETKA only has the whole grill,...

    From what I see, ETKA only has the whole grill, not just the surround. 4B3 807 647 F. Then below, it gives a date and code 1L1 for matt-alluminum
  19. Replies
    17
    Views
    7,274

    The cable for the hood latch can sometimes cause...

    The cable for the hood latch can sometimes cause a snag, as well as a the thin plastic bleed line going from passenger side upper radiator hose back to the firewall. Jiggling does help a lot,...
  20. Replies
    37
    Views
    15,848

    Do you have a PN for this? Cant seem to find it...

    Do you have a PN for this? Cant seem to find it in ETKA, just PN for whole VB harness.
  21. Its not hard, but its a bit of work. I did it to...

    Its not hard, but its a bit of work. I did it to my A6 when I pulled the dashboard, so I am not sure what *wasn't* necessary to remove from the front of the car. Start with removing arm rest as...
  22. Replies
    37
    Views
    15,848

    More or less, yes.

    More or less, yes.
  23. Replies
    7
    Views
    2,797

    http://www.rs6.com/showthread.php/26560-75k-servic...

    http://www.rs6.com/showthread.php/26560-75k-service-coming-up-anything-I-should-check-beyond-recommended-maintenance

    Check for leaks..

    Forget bigger turbos unless you want to spend redic money....
  24. Replies
    37
    Views
    15,848

    That will be next on the hit parade..

    That will be next on the hit parade..
  25. Replies
    37
    Views
    15,848

    Fixed the wiring over the weekend. Re-soldered...

    Fixed the wiring over the weekend. Re-soldered all 3 wires to the knock sensor. another problem was the plug, it had a crack in the flange, so it wouldn't always click all the way in if wires were...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4