I'll get pics shortly. Yes, directional. Been boxed up for a bit.
Type: Posts; User: alrightroad
I'll get pics shortly. Yes, directional. Been boxed up for a bit.
Ready for new home. You will need to defeat existing immo or transfer your immo.
4D1 907 558 D
$375 shipped
Have all 4 sitting collecting dust. New, unmounted, still in plastic bags.
$750 for front pair shipped
$650 for rear pair shipped
Nice one Steve.
Guys, sorry for delay here... ECU and TCU are sold.
I do have another stock ECU that I want to unload also. Immo is NOT defeated, FYI. $400 shipped.
Hello folks,
I've got a spare ECU with Marc's tune on it (10secS4). ECU has immobilizer defeated and ready for new home. $550.
I also have a TCU with MTM chip/sauce onboard ready for new...
I'll be waiting.
Ready to ship. I purchased from Scotty at Advanced a while back and will not be using. $175 shipped within 48 states. Good condition. Will email pictures to interested parties upon request.
Interesting feedback. My rotors didn't have that cream colored coating when I purchased. Coating was clear.
Thanks guys. I have thought about removing the RNS-E and may just do that. Good thought.
Thanks guys. I have thought about removing the RNS-E and may just do that. Good thought.
RS Family. I am moving on. Sad to see her go. Checking in here to see if any interest before listing publicly. 03 RS6, US-spec, stock, Daytona/Ebony, wood trim, SE exhaust, RNS-E (latest gen), I...
oops. Corrected price. Thank you!
I also have an S6 ABS block with hard pipes for sale for you 6MT-want gentlemen.
http://www.ebay.com/itm/321694506822
Thanks guys.
Eric
If you still need, I have an extra stock TCU you can borrow. send me PM with email address. easier for me to communicate that way...
-eric
Yikes, that was a little large :)
Don't forget... https://www.vinylmark.com/media/catalog/product/cache/1/image/960x720/9df78eab33525d08d6e5fb8d27136e95/a/u/audi-dope-decal-black.png
I'll be doing dial/run-out measurements on both new OEM and the JHM's on two different cars over the next few weeks as I get to it. Will also resurface the JHM's after dial measurements and then...
Hahn, please pm me. thx.
I approve the contents of this thread!
Care to post some pics and specs?
Essex, great input here... thank you. I'm going to experiment with different pad material and resurfacing of rotors each time. So far, my conversations with JHM have yielded not 1% of assumption of...
Hat bolts are solid. I checked/torqued them all before install. Funny thing is I am using Hawk HPS. Same pads on the RS6 setup. Pads only have ~100 miles on them between both rotor sets. I'm...
I purchased all 4 lightweight ones for my allroad project which has all 4 new RS6 calipers, hubs, bearings, uprights, etc. etc. Bed-in procedure was done properly following the recommended famous...
MTM built up the Gumpert motor from what I recall. Read on the history of Gumpert and you will see the two proprietors are buds.
15744
http://www.3dtuning.com/en-US
Site is a little slow so be patient. Great way to waste some time.